Gyrodec SE $4299 (with Techno Arm)
Based entirely on the GyroDec, but without the costly acrylic plinth and dustcover, the Gyro SE brings the same qualities in a more affordable and compact package. A Michell Gyro SE can always be converted into a GyroDec by purchasing a plinth and dustcover.
Spider chassis, suspended stable subchassis
Massive acrylic/vinyl platter of high inertia, with gold-plated brass weights
Inverted oil-pumping bearing
Custom arm boards available for most tonearms
High-quality standalone DC motor
Optional clamp
Optional HR supply
Optional Orbe-style platter and clamp
Optional dust cover
Finished in silver
Orbe SE $7495 (excl. Tonearm)
By eliminating much of the expensive acrylic, the Michell Orbe SE offers most of the Orbe’s qualities in a cheaper, smaller, and to some people aesthetically more pleasing package. An Orbe SE can always be upgraded to a full Orbe by purchasing the double plinth and dustcover. When teamed with an RB250 or RB300 tonearm, the Orbe SE is a surprisingly affordable entry to the Orbe-class of performance.
Spider double chassis, suspended pendulum subchassis
Damped subchassis
60 mm thick massive acrylic/vinyl platter of high inertia
Screw-down record clamp
Inverted bearing
Custom arm boards available for most tonearms
High-quality standalone DC motor with tacho feedback speed control
Orbe Controller NC supply with Never-Connected circuit
Optional dust cover
Finished in black or clear acrylic with black metal parts
HR Power Supply $1199
The HR Power Supply is a low-noise electronic power source for the DC motors as found on the TecnoDec, GyroDec and Gyro SE turntables. Adding extra stability to the power supply for the motor, the HR features the novel Never-Connected circuit, and has a user-adjustable speed control on its back plate.
Fitting is simple – just unplug the motor lead from the existing supply and connect it to the HR. An IEC mains lead comes supplied.
Techno Arm from $1399
The Tecno Arm “A” is a fundamental mechanical rebuild of the well-known RB250 tonearm, to which is added monolithic wiring of the highest quality. The arm tube is bead-blasted and perforated, which disperses structural resonances and yields a lower effective mass. The arm wand is internally damped to reduce resonance further, and the headshell is machined flat, to allow true azimuth relative to the bearing cradle. After modification the bearings are re-adjusted for highest possible performance, according to original Rega procedures.
One-piece perforated arm casting with internal foam damping
Proprietary silver litz cable in a continuous run from cartridge to amplifier
PTFE dielectric, metal braided shielding, separate ground wire
Silver-plated cartridge clips and phono plugs
Two counterweights, matching cartridges of 4-7g and 7-13g
Vertical tracking force adjuster in steps of 0.1g
Vertical tracking angle adjuster
Finger locknut for easy arm removal or VTA adjustment
One year warranty
The Techno Arm “A” is also available in black.
