Triode Corporation

Made in Japan

TRI TRV-35SE Vacuum Tube Integrated Amplifier $2999
-Output class AB: 45 watts at 8 ohms
-Frequency response: 10Hz – 100kHz (+/- 4dB)
-Input impedance: 100K ohm
-Output: 6 & 8 ohm speaker and 1 Headphone terminal
-Input terminals: 4 (1 front, 3 back)
-Output terminals: 1 rec out

TRV-A300SE $2999
300B single ended integrated amplifier
Max power class A: 8watts +8watts at 8 ohms
Frequency response: 15Hz- 50 kHz (+/- 1dB)
Total distortion: 0.3%(1kHz)
SN level: 85dB
Input sensitivity: 0.6V
Input impedance: 100kohm
Output: 6 and 8 ohm speaker taps
Input terminals: 3 (LINE 1 / 2 / 3)
Self bias
Power consumption: 80watts
Tube Compliments 2- 300b 2- 6SN7
Components used:TOICHI oil capacitors(Japan)
KOA highly precise resistors(Japan)
Weight 11.5kg
Dimension W220mm x D372mm x H 190mm

TRI TRV-4SE Preamplifier $2999
Tube Pre-Amplifier
Circuit: CR type Class A amplification
Phono Circuit: NF type, MM cartridge
Frequency Characteristic: -1 and -3db (10Hz-100KHz)
Signal to noise ratio: 96db
Output Impedance: 7Kohm
Input Terminal: 4 line (one pair front and three pairs rear),
one pair record out
Output Terminal: three lines
Tube compliment:
6-ECC83-amplification stage
2-5AR4 Rectifications
Weight 8kg
Dimension: W340 x D315 x H185 (mm)

TRI TRV-M88SE Power Amplifiera $3250 Special limited price Normally $5250

KT88 push-pull mono power amplifier
Output: Class AB, 50watts at 8 ohms
Frequency response: 20Hz- 55 kHz (+/- 1dB)
Total distortion: 0.1%(1kHz)
SN level: 90dB
Input sensitivity: 0.7V
Input impedance: 100kohm
Output: 6 , 8 , 16ohm speaker taps
Input terminals: 1 balanced, 1 unbalanced
Power consumption: 60watts(no signal), max 120watts
Tube Compliments: In each mono block
2- KT88 1-12AX7 (ECC83) 1- 12AU7 (ECC82)Weight 15kg
Dimension: W176mm x D440mm x H 200mm